Search found 7 matches
- Thu Mar 21, 2019 8:06 pm
- Forum: Tips and Tutorials
- Topic: Make sure machine is LEVEL.
- Replies: 2
- Views: 12160
Make sure machine is LEVEL.
Always check the little bubble Level on your machine to make sure it is on a flat plane. I have always had good but slightly mixed results with my machine over 3 years. I never once checked the level after setting it up. I started having lines on my prints and fails the last little bit and this seem...
- Thu Jan 19, 2017 3:57 am
- Forum: Help and Troubleshooting
- Topic: Projector Power Light Randomly Turns On
- Replies: 3
- Views: 6557
Re: Projector Power Light Randomly Turns On
Thanks, I will try it. I have relocated my printer since its been happening so all the cables have been unplugged and plugged back in and it still happens but let me try reconnecting everything again.
- Thu Jan 19, 2017 3:44 am
- Forum: Help and Troubleshooting
- Topic: Projector Power Light Randomly Turns On
- Replies: 3
- Views: 6557
Projector Power Light Randomly Turns On
My projector power light keeps randomly projecting during prints and curing a small rectangle on the film where it is. I have the Infocus projector that was recommended when I bought the printer. Just to be clear it is the tiny orange rectangle that turns on when you press the power button twice to ...
- Tue Oct 18, 2016 7:18 am
- Forum: Help and Troubleshooting
- Topic: Printer controls locked up.
- Replies: 3
- Views: 6200
Re: Printer controls locked up.
That worked for the arm to move up but when I $h again it does the same thing. I did tried to do prints and the keep failing. I don't think the tilt is working on the quartz table, I can usually hear it when its printing and I dont.
- Mon Oct 17, 2016 10:57 pm
- Forum: Help and Troubleshooting
- Topic: Printer controls locked up.
- Replies: 3
- Views: 6200
Printer controls locked up.
My printer controls are locking up after I do a $h command. It won't let me jog up after it goes to home position. All the controls just lock up and I have to restart the computer and do $x command to get it to let me move the arm up and then when I do $h again it locks up. Been trying to get it to ...
- Sun Mar 13, 2016 3:42 am
- Forum: Help and Troubleshooting
- Topic: White film collecting in bottom of resin tank
- Replies: 3
- Views: 6804
Re: White film collecting in bottom of resin tank
Mixed it up the best I could and got as much of it off the bottom as I could. Went ahead with the print and it cam out... I will post a picture when it settles to the bottom again.
- Sun Mar 13, 2016 12:31 am
- Forum: Help and Troubleshooting
- Topic: White film collecting in bottom of resin tank
- Replies: 3
- Views: 6804
White film collecting in bottom of resin tank
Hello, I am using Emerald resing and haven't printed anything for a few days... When I went to set up a print I looked underneath the resin take and there is a white film collecting inside the resin. Is this normal? Is the resin inside the tank contaminated? Will this affect my print if I go forward...