Search found 1798 matches

by mongerdesigns
Thu Feb 21, 2019 6:23 pm
Forum: Resins
Topic: ResinWorks EasyCastHD castable resin
Replies: 38
Views: 2156

Re: ResinWorks EasyCastHD castable resin

That info was mentioned in this thread.
by mongerdesigns
Thu Feb 21, 2019 5:16 pm
Forum: Software
Topic: Contour Feature Requests
Replies: 17
Views: 4854

Re: Contour Feature Requests

You can then move the models around and hit regenerate supports.
by mongerdesigns
Thu Feb 21, 2019 5:14 pm
Forum: Resins
Topic: ResinWorks EasyCastHD castable resin
Replies: 38
Views: 2156

Re: ResinWorks EasyCastHD castable resin

Not sticky at all. It's a really good resin. I suggest printing at 42xy build area with it for best results. Haven't had a single bad print or bad casting. It's miles better than the emerald and easier to post cure. Just cure in water for 30min - 1 hour under UV. Or for better results in glycerin or...
by mongerdesigns
Wed Feb 13, 2019 6:52 am
Forum: Help and Troubleshooting
Topic: Round Disks Print Oval
Replies: 3
Views: 232

Re: Round Disks Print Oval

Print a 10mmx10mm cube. Then measure it. Enter the values you're getting on the bottom row. The Z can stay 10.
by mongerdesigns
Mon Feb 11, 2019 5:38 pm
Forum: Help and Troubleshooting
Topic: Round Disks Print Oval
Replies: 3
Views: 232

Re: Round Disks Print Oval

If you have checked everything, you can use the Scaling Compensation to adjust this. It's under File, Setup.
by mongerdesigns
Wed Feb 06, 2019 5:23 pm
Forum: Gallery
Topic: ***Totally Stoked!!***
Replies: 381
Views: 100008

Re: ***Totally Stoked!!***

Excellent work as usual and supports. Just so you know Mark, we're training an AI to replicate your supports work.... jk....or am I? :)
by mongerdesigns
Mon Feb 04, 2019 5:09 pm
Forum: Help and Troubleshooting
Topic: Home Cycle failure
Replies: 1
Views: 159

Re: Home Cycle failure

Could be the homing sensor. I suggest contacting support at info@junction3d.com
by mongerdesigns
Fri Feb 01, 2019 8:17 pm
Forum: Help and Troubleshooting
Topic: Bending in prints
Replies: 3
Views: 223

Re: Bending in prints

The Grid Calibration is self-explanatory. Grab the point and move them on the screen and watch the grid change. You need to move the side ones out a tiny bit and you can correct that bowing. Easy peasy. Just don't use the corner points to make the grid smaller to fit. That's what the physical zoom w...
by mongerdesigns
Fri Feb 01, 2019 7:17 pm
Forum: Hardware
Topic: settings for INFOCUS DLP. Please
Replies: 1
Views: 274

Re: settings for INFOCUS DLP. Please

In the manual
by mongerdesigns
Thu Jan 31, 2019 4:51 pm
Forum: Hardware
Topic: Printer is locked up
Replies: 1
Views: 101

Re: Printer is locked up

Hi Tom,

I suggest contacting support at info@junction3d.com for help with this.