Search found 27 matches
- Sun Jan 28, 2018 12:28 am
- Forum: Hardware
- Topic: Stuck on home cycle, motors won't turn
- Replies: 22
- Views: 45562
Re: Stuck on home cycle, motors won't turn
What email address do I need to use to contact you?
- Sat Jan 27, 2018 7:32 pm
- Forum: Hardware
- Topic: Stuck on home cycle, motors won't turn
- Replies: 22
- Views: 45562
Re: Stuck on home cycle, motors won't turn
it moves with my hand. It does everything but once it goes down it stays down and the motor does not revers to move back up.
- Sat Jan 27, 2018 12:26 am
- Forum: Hardware
- Topic: Stuck on home cycle, motors won't turn
- Replies: 22
- Views: 45562
Re: Stuck on home cycle, motors won't turn
I had the same issue. I will go down but won't return to home. I tried your reset but it remains down.
- Fri Jul 08, 2016 11:34 pm
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050
Re: Fail ring print with B9 Emerald
I went back and checked all my setting. Misted one setting in the projector. The print was better but still failed. I added some MJ cast to the emerald green and it worked.
- Sun Jul 03, 2016 1:49 pm
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050
Re: Fail ring print with B9 Emerald
In tools and tips the following note was posted. I don't see how to check these settings. For the Optoma HD37, we recommend the following settings. DISPLAY MODE: Reference Brightness: 0 Contrast: 15 Sharpness: 15 Gamma: 1.8 Lamp Mode: ECO High Altitude: On Note: The Power Mode should remain unchange...
- Sun Jul 03, 2016 12:17 pm
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050
- Sat Jul 02, 2016 8:59 pm
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050
Re: Fail ring print with B9 Emerald
I'm using the Optoma HD37 1080p 3D DLP Home Theater Projector. Yes I remove the filter. I did print a couple of things but more failures than success. :? I rechecked the projector settings and they were not correct. I made the corrections now printing. I'll provide status one cycle is complete. ;) M...
- Sat Jul 02, 2016 12:48 am
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050
Re: Fail ring print with B9 Emerald
I'm almost there. Most of the ring printed correctly. I tried twice. See attachment. Any suggestions,
- Fri Jul 01, 2016 9:03 pm
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050
Re: Fail ring print with B9 Emerald
Thanks,
What are the steps when using netfabb?
What are the steps when using netfabb?
- Fri Jul 01, 2016 5:45 pm
- Forum: Resins
- Topic: Fail ring print with B9 Emerald
- Replies: 20
- Views: 34050