Search found 10 matches
- Sun Nov 04, 2018 4:01 pm
- Forum: Hardware
- Topic: Vivitek H1189
- Replies: 3
- Views: 13601
Re: Vivitek H1189
some more pictures
- Sun Nov 04, 2018 3:44 pm
- Forum: Hardware
- Topic: Vivitek H1189
- Replies: 3
- Views: 13601
Vivitek H1189
This is my new projector for Solus Vivitek H1189, I use it for about two months,before this more than a year I used the Vivitek H1186.The exposure time is 3.3 ~ 3.5 seconds, the lamp model is the same as for Vivitek H1188 The 42mm high bracelet was printed in 3:27 hours, the platform lift height was...
Re: 1.9.4v
Thanks, i will try to fix this using the grid.
Re: 1.9.4v
Jewelermdt wrote:I would not complain about .2 off in all corners. I believe you get this because of the curved lens is going to bend the light to some degree.
Thanks for answer.Can be replaced with a more accurate lens that comes with the printer?
Re: 1.9.4v
Hi guys
please tell me how can I fix this distortion, I tried all the known variants?a cube in the corners does not work 10x10, maybe 2 out of four turns out 10x10, with the central cube no problems.
please tell me how can I fix this distortion, I tried all the known variants?a cube in the corners does not work 10x10, maybe 2 out of four turns out 10x10, with the central cube no problems.
- Mon Nov 27, 2017 3:17 pm
- Forum: Help and Troubleshooting
- Topic: Uneven illumination of the projector lamp
- Replies: 2
- Views: 6551
Re: Uneven illumination of the projector lamp
After cleaning the optics from dust, the lamp power increased
- Fri Nov 24, 2017 12:04 pm
- Forum: Help and Troubleshooting
- Topic: Uneven illumination of the projector lamp
- Replies: 2
- Views: 6551
Uneven illumination of the projector lamp
Hi guys
please tell me how can I fix this problem, the lamp power is uneven, the right side always produces a marriage,as you can see in the picture the difference is big.
Thank you
please tell me how can I fix this problem, the lamp power is uneven, the right side always produces a marriage,as you can see in the picture the difference is big.
Thank you
- Mon Jul 03, 2017 5:10 pm
- Forum: General
- Topic: Print defect
- Replies: 3
- Views: 8000
Re: Print defect
Yes, at the same height,Not only on the ring, on almost every model at the same height
https://ibb.co/c7QoCv
https://ibb.co/djv5sv
https://ibb.co/c7QoCv
https://ibb.co/djv5sv
- Sun Jul 02, 2017 3:39 pm
- Forum: General
- Topic: Print defect
- Replies: 3
- Views: 8000
- Sun Jul 02, 2017 1:33 pm
- Forum: General
- Topic: Print defect
- Replies: 3
- Views: 8000
Print defect
Hello. I've been using the solus printer for a few months, for a few weeks on the models there were strange stripes, there was not any before, please tell me how to get rid of these strips, the strips turn out to be convex or internal, And appear on the outside of the model, I changed the film, Made...