Search found 4 matches
- Wed Aug 15, 2018 3:47 am
- Forum: Help and Troubleshooting
- Topic: failed prints
- Replies: 6
- Views: 9999
Re: failed prints
ive had the exp up to 2.5s and worked down and the base was at 15s I think there has been several issues here i am now running 8s for first layer then now 2s i have also increced the base to 6mm with 1.5mm supports just to add extra stubility i have also gone from .3mm to .4mm with some manual suppo...
- Tue Aug 14, 2018 5:36 am
- Forum: Help and Troubleshooting
- Topic: failed prints
- Replies: 6
- Views: 9999
Re: failed prints
if I lay the ring on the side all prints well but just not when they are standing up
here are just a few photos
here are just a few photos
- Tue Aug 14, 2018 5:21 am
- Forum: Help and Troubleshooting
- Topic: failed prints
- Replies: 6
- Views: 9999
Re: failed prints
also im using .4 support tips and adding in a few .6tips at the bottom and half way up
this photo I had the base exp up to high
this photo I had the base exp up to high
- Tue Aug 14, 2018 5:06 am
- Forum: Help and Troubleshooting
- Topic: failed prints
- Replies: 6
- Views: 9999
failed prints
ive been getting a lot of failed prints I have done everything I know to do replaced the film. recalibration of print head clean and refocus all retina pathways base exp is at 7s then at 1.5s I have tried down to 1.3s and up to 2.2s it is printing the galery wires nad will fail the ring half way thr...