Search found 787 matches
Re: help
My problem also. usually it's because of not enough supports or they are in the wrong place.
- Tue Sep 08, 2015 3:07 am
- Forum: Hardware
- Topic: Platform not level
- Replies: 13
- Views: 22292
Re: Platform not level
Ok got platform level. Looks like all the supports started but failed. What could cause this? New film in vat. New resin[img]
[/img].- Mon Sep 07, 2015 2:12 am
- Forum: Hardware
- Topic: Platform not level
- Replies: 13
- Views: 22292
Re: Platform not level
ok Will do. It was late Saturday afternoon when I discovered that. So what is the best email address. You and Emil. You should list this in your profile. PM don't always work cause I don't check the forum often during the day.
- Sun Sep 06, 2015 12:57 am
- Forum: Hardware
- Topic: Platform not level
- Replies: 13
- Views: 22292
Re: Platform not level
Got the answer from Monger posted it on 3Dcad forum.
- Sat Sep 05, 2015 7:27 pm
- Forum: Hardware
- Topic: Platform not level
- Replies: 13
- Views: 22292
Re: Platform not level
The difference from front to back is worse than the pictures looks. Just the angle I took the picture.
- Sat Sep 05, 2015 7:25 pm
- Forum: Hardware
- Topic: Platform not level
- Replies: 13
- Views: 22292
Platform not level
Tried a larger print today. Half of the supports stuck to the film half to the build plate. Front ones on plate back ones on film. I'm guessing the build platform should be flush with the quartz plate when starting? Mine is not level.
Re: help
found some Adhesive tape for a "Command" hook. Just the right thickness I needed. Looks like it will work to hold it tighter on the projector just fine. Trying a new print today.
Re: help
Have not had a lot of time to check out my setup. But today I did notice that my close up lens does not fit snug on the projector lens. It tilts about 2 to 3mm. Guessing this will cause blurred / out of focus images. Will work on that tomorrow. Tried a wide rubber-band on P lens but it was too thick.
- Fri Sep 04, 2015 2:15 am
- Forum: Hardware
- Topic: Vat Diaphragm Replacement Instructions
- Replies: 4
- Views: 9908
Re: Vat Diaphragm Replacement Instructions
Could you send those instruction to me also.
Thanks
Mike
Thanks
Mike
Re: castings
Believe he is using the B9 Cherry