Reify3D Forum

HI All, After running the solus for nearly 2 years swapped to new control computer old one dying looking for current setup instructions running Contour with Vivitech and NVDIA graphics card.
Found this link
https://reify3d.wistia.com/projects/ztww6a0tqj
Missing all the RGB setup and other install info that I vaguely remember.
A pointer to current install procedure would be appreciated.
thanks

HI,

I'll email you the manual now.

Hi Mark,
Havent received the new document - I found my install instructions but they where for win8 and CW. I have installed ARDUINO 1.68 seems current is 1.85 I have done the RGB full install - in contour I can connect to Solus but wont run home cycle.

Do I need to still install CW? havent used since moving to Contour.

can you raise and lower Z? If not might be the cable. Try different port. In device manager make sure it's turn on and power set to never go idle. Reinstall might have changed these settings. You don't need CW if you have Contour.