Make sure machine is LEVEL.
Posted: Thu Mar 21, 2019 8:06 pm
Always check the little bubble Level on your machine to make sure it is on a flat plane. I have always had good but slightly mixed results with my machine over 3 years. I never once checked the level after setting it up. I started having lines on my prints and fails the last little bit and this seems to be part of the issue. I have my machine on a solid desk but I noticed it still gets knocked off level pretty easy between the desk getting hit and replacing the film. I started making sure it is level before I hit start each time and a lot of the lines and failures have cleared up. This is just one of the keys to better prints... film tension and machine calibration are all factors and the machine being level is part of that.