20 or 25
-
- Novice
- Posts:33
- Joined:Fri Dec 11, 2015 5:03 am
Hey all I'm printing b9 green using the 42xy but the default is 25 can I go down to 20 without making any changes. some of my prints are not as sharp and bowing on some edges. I checked the calibration and homed It, done all the basics. the film is questionable still looks clean and no major dimples on it so don't know. I'm hoping a thinner slice might help detail and print?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: 20 or 25
Yes, you can just lower it to 20 microns without any other changes.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: 20 or 25
Morgan, is it better to print at 20, as i never tryed it ?
Re: 20 or 25
I like 20 and do a lot of printing in 20. Mostly the more delicate more detailed pieces.
Who is online
Users browsing this forum: No registered users and 6 guests