Procedure or Check List for 25 to 41 and back again.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Just measure how much you need to move it, then point the projector at the wall and move it from the menu in that direction. The horizontal shift is limited to about 50 pixels to the left or to the right, so it's not a huge move.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Procedure or Check List for 25 to 41 and back again.
Will try that. I don't have a whole lot of room between projector to wall. Right now it's 15in laptop projector printer. Just enough room to open printer lid and not hit wall. I run a fan to keep things cool.
Re: Procedure or Check List for 25 to 41 and back again.
Hi
Could you please send me the instructions on this subject as well? Thanks---------------Gary
Could you please send me the instructions on this subject as well? Thanks---------------Gary
Re: Procedure or Check List for 25 to 41 and back again.
Hi,
PMed them to you.
PMed them to you.
Re: Procedure or Check List for 25 to 41 and back again.
Hi all, i'm new here and getting ready to purchase a Solus. Sooo, I would like to get this instructions just to start and familiarise myself with the unit. Actually any info a noob should know, please feel free to send it.
All the best,
Mark
All the best,
Mark
Re: Procedure or Check List for 25 to 41 and back again.
Might as well send me a copy as well. I have a few larger pieces to print in the near future. Thanks Mark
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Procedure or Check List for 25 to 41 and back again.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 6 guests