Procedure or Check List for 25 to 41 and back again.

[reify]

Hi
Would be grateful if you could send me the instructions on this subject. Thanks

Hi David,

I just emailed them.

[toddmichael]

If someone could email me the instructions for this too, i would greatly appreciate it?

support@facetsoftoddmichael.com

or PM me here, or both, to make sure i get them, please???

Toddmichael

[mongerdesigns]

Just emailed them to you Todd.

[EddyF]

Can you send me, I have not got anything to print 41. Does the filter need to me back on.

[Jewelermdt]

No to the filter.

what's your email?

Check your calibration gird. Make sure it's lined up in the middle of the quartz table. Before putting a thin piece of paper on top be sure the grid does not go down the sides of the quartz. Then focus the gird and measure the grid.

[CADjewelrySchool]

Did you change the resin profile for XY41?
You need longer base exposure and longer exposure for XY41 as the projector is set further away from the printer.

Can you send me, I have not got anything to print 41. Does the filter need to me back on.

[EddyF]

I think my grid is not centered

[Jewelermdt]

Eddy Sent you an email with instructions. Mine is not centered either. Don't know if the plate was drilled off or what. Had to manipulate projector and printer for it to get in middle of table.

[reify]

Hi,

You can use the horizontal shift in the projector menu to move it over a bit.

[Jewelermdt]

Ok How do you do this when you need the grid showing to move it? Kind of small print to read from the table.