Solus Art Grey Resin trouble

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Robert
Novice
Posts: 53
Joined: Sat Apr 29, 2017 2:58 pm

Solus Art Grey Resin trouble

Postby Robert » Wed May 13, 2020 9:04 am

Hi folks,

Has anyone had all manner of trouble with this Art grey resin? I have tried 5 prints, a lot of different settings and all I can muster is some grey resin discs stuck to the plate, with no supports building.

Are there any settings people suggest?

Should I be using thicker supports?

Cheers
Rob
Mikkopee
Novice
Posts: 46
Joined: Mon Feb 13, 2017 1:18 pm

Re: Solus Art Grey Resin trouble

Postby Mikkopee » Wed May 13, 2020 12:26 pm

Robert wrote:Hi folks,

Has anyone had all manner of trouble with this Art grey resin? I have tried 5 prints, a lot of different settings and all I can muster is some grey resin discs stuck to the plate, with no supports building.

Are there any settings people suggest?

Should I be using thicker supports?

Cheers
Rob

Have you tried other resins? Lamp hours?
User avatar
Jewelermdt
Solus Master
Posts: 798
Joined: Sun Jul 19, 2015 10:38 pm
Location: N.W. Florida
Contact:

Re: Solus Art Grey Resin trouble

Postby Jewelermdt » Thu May 14, 2020 12:41 am

Make sure you're using the correct resin profile for printing it? Ghost run around in my computer, especially after an windows update.
I think I have seen where you might need to use bigger support tips and tubes. A lot depends on what your printing. Large items need bigger supports. I have to increase my sizes using Solus Wax Pro for things like bracelets.

Who is online

Users browsing this forum: No registered users and 6 guests