Adjusting Gamma, Contrast, and Brightness
Its quiet that's for sure. I really like the machine, its just getting my head wrapped around how it works. FYI I think I did have the Vat Film too tight because I watched the video tutorial again and adjusted a new film in the Vat and that sound went away.
Best Regards,
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Adjusting Gamma, Contrast, and Brightness
Luke
Check you setting in device manager so the the USB ports do NOT turn off or go idle on non use.
Check you setting in device manager so the the USB ports do NOT turn off or go idle on non use.
Re: Adjusting Gamma, Contrast, and Brightness
3dLuke wrote:Its quiet that's for sure. I really like the machine, its just getting my head wrapped around how it works. FYI I think I did have the Vat Film too tight because I watched the video tutorial again and adjusted a new film in the Vat and that sound went away.
The vat should only sit about 0.5mm above the printer before the thumbscrews are installed.
Who is online
Users browsing this forum: No registered users and 39 guests