print failure

[nillard]

Change your film... It's probably too loose or dimpled

[reify]

Hi,

Can you please email this supported stl to Konstantinos or me to check?

[Jewelermdt]

Looks like a lot of flashing on bottom layer. Wonder if he still has some settings wrong.

What type computer do you have? Graphics card? Win7 or 10?

[reify]

Looks like a lot of flashing on bottom layer. Wonder if he still has some settings wrong.

What type computer do you have? Graphics card? Win7 or 10?

Sure does look like it.

[kolovos70]

Im using win 10 and I don't thing is a problem with the supports because that happens also with the test models.

[kolovos70]

This is the secont print with this film.
And i installed the film according to video tutorials.

[mongerdesigns]

What type of graphics does your PC have? Is it Intel or nvidia? Did you set the full rgb according to the instructions? Are you using the hdmi cable?

[kolovos70]

Im using intel grafings and it is foul rgb and HDMI cable

[mongerdesigns]

Please put the resin tank on but don't tighten the two knobs. Then take a photo directly from the front. I want to see how much of a gap there is. If there is no gap, your film is too loose.

[kolovos70]

I send ypu images from the vat.
In front the gap is more than back.