print fail, seem projector lamp too old
I cant not print someday ago. Projector light is flicker, flash when eco mode, normal mode no flicker but i cant print successfull. Fail at end of support, have some strange surface solid at model. Pls help me. My project hourse is 3500h eco and 150 normal
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: print fail, seem projector lamp too old
3500 hours is way past due for a replacement. We recommend replacing the bulb at 2000 hours.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: print fail, seem projector lamp too old
how can i replacement for vivitek 1186
Any suggest for lamp bulb buying
Thanks for help, i cant do anything in 2 months, dont know what problem but print cannot successful because model seems blur on project
Any suggest for lamp bulb buying
Thanks for help, i cant do anything in 2 months, dont know what problem but print cannot successful because model seems blur on project
Re: print fail, seem projector lamp too old
Hi,
I am waiting for pricing of replacement bulbs from Vivitek. I'll email you when I know.
I am waiting for pricing of replacement bulbs from Vivitek. I'll email you when I know.
Re: print fail, seem projector lamp too old
reify wrote:Hi,
I am waiting for pricing of replacement bulbs from Vivitek. I'll email you when I know.
Now i cant $h, motor not stop when go home, and can go up in solus
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: print fail, seem projector lamp too old
Turn off power to printer. Turn Z screw by hand to raise up. Power on, restart CW.. You should get the Contour software. It's much easier to use.
Re: print fail, seem projector lamp too old
i run home cycle in solus but when z go to home position, motor still run, after a few second motor stop but software still load, dont recognise that home, dont go up
Re: print fail, seem projector lamp too old
Sometime I have the same problem, for me the problem was a too tight VAT the quartz can't till properly.
Re: print fail, seem projector lamp too old
haipham wrote:Thanks for help, i cant do anything in 2 months, dont know what problem but print cannot successful because model seems blur on project
If you got a blurry projection and it doesn't appear to be focus-related, then you have some other issue, like dirty filter glass or internal optics inside the projector itself that needs to be dealt with first.
Re: print fail, seem projector lamp too old
mongerdesigns wrote:3500 hours is way past due for a replacement. We recommend replacing the bulb at 2000 hours.
When in eco mode, picture project on wall are flicker, normal mode resolve it but cant still print
Who is online
Users browsing this forum: No registered users and 35 guests