Hello, still there is a line
Posted: Sun Oct 22, 2017 3:37 am
Hello,
I posted same issues here http://reify-3d.com/forum/viewtopic.php?f=11&t=972
So, I bought new film and calibrate everything.
The print quality is way better than before but there is still the problem with one layer.
All other layers are clean but only same layers always jammed.
I guess it could be the rods or linear stage problem.
Can someone please help me with this issues?
I posted same issues here http://reify-3d.com/forum/viewtopic.php?f=11&t=972
So, I bought new film and calibrate everything.
The print quality is way better than before but there is still the problem with one layer.
All other layers are clean but only same layers always jammed.
I guess it could be the rods or linear stage problem.
Can someone please help me with this issues?