Hey folks,
I've emailed Mark and Jordi about this to see if they know, but I thought I would also ask here in case anyone has already had this issue, or there's something really obvious that I have missed.
Sadly, I tried to run the machine today as usual, but partway through the homing cycle, I think the connection broke and now the z-screw will not home at all. I can manually move it up and down, like you can when the machine is powered down, but I can do this whether there is power, or no power. Very strange.
I've tried taking it apart and having a look, I have also taken the connections off and put them back on but doesn't seem to be working.
Cheers in advance!
Small issue with z-screw homing
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Small issue with z-screw homing
Sounds like a bad motor. Or like you said a broken wire-connector.
Re: Small issue with z-screw homing
Could also be a bad motor driver.
Re: Small issue with z-screw homing
Sounds like bad motor from doing some tests with Mark and Jordi.
Amazing help from the team as always.
Amazing help from the team as always.
Who is online
Users browsing this forum: No registered users and 11 guests