Warping in Print (Z)
Posted: Thu Apr 26, 2018 11:38 am
Hey guys,
So I have done all the scaling checks, calibration etc on the printer and have found that my prints are coming out warped.
This is worse with taller models.
Now, I also have had to lift the projector at the rear, using the screws underneath to lift it up. I'm wondering if the trajectory of the light it causing this? I can't see how it would, as the grid appears to be perfect to me.
I have also had to disassemble my Solus before, so I wonder if I knocked the mirror, or if the mirror is no longer where it should be.
I also wonder if, perhaps, the bulb is not in the projector quite how it should be.
What would you recommend I do to troubleshoot this? I've contacted my local distributor for advice, but figured a wider spread request for knowledge might be handy, to see if anyone else has had this issue. Obviously for printing rings, etc, this kind of problem is quite a big one - so I'm sure it's easily resolved.
So I have done all the scaling checks, calibration etc on the printer and have found that my prints are coming out warped.
This is worse with taller models.
Now, I also have had to lift the projector at the rear, using the screws underneath to lift it up. I'm wondering if the trajectory of the light it causing this? I can't see how it would, as the grid appears to be perfect to me.
I have also had to disassemble my Solus before, so I wonder if I knocked the mirror, or if the mirror is no longer where it should be.
I also wonder if, perhaps, the bulb is not in the projector quite how it should be.
What would you recommend I do to troubleshoot this? I've contacted my local distributor for advice, but figured a wider spread request for knowledge might be handy, to see if anyone else has had this issue. Obviously for printing rings, etc, this kind of problem is quite a big one - so I'm sure it's easily resolved.