New printer - doesn't do Homing

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
MargoArgo
Novice
Posts:28
Joined:Wed May 30, 2018 1:12 pm
New printer - doesn't do Homing

Postby MargoArgo » Sun Jun 03, 2018 8:39 pm

Hi all,
so I've got my new printer, assembled, set up and calibrated it, opened a calibration box model in Contour - and voila, the printer doesn't start homing. Unplugged USB (COM6 port if it's important), turned off printer, then put it back - again nothing. Contour SW sees it on COM6, but no Homing. Any ideas why? other than bad karma..

Thank you!
User avatar
reify
Site Admin
Posts:571
Joined:Mon Mar 16, 2015 6:10 pm

Re: New printer - doesn't do Homing

Postby reify » Sun Jun 03, 2018 9:58 pm

Hi,

Did you download and install the arduino software? It has the drivers you need to run the printer.

Where are you located?
MargoArgo
Novice
Posts:28
Joined:Wed May 30, 2018 1:12 pm

Re: New printer - doesn't do Homing

Postby MargoArgo » Mon Jun 04, 2018 5:32 am

reify wrote:Hi,

Did you download and install the arduino software? It has the drivers you need to run the printer.

Where are you located?

Hello,
yes I have, and I'm in Amsterdam.

Who is online

Users browsing this forum: No registered users and 10 guests