New printer - doesn't do Homing
Posted: Sun Jun 03, 2018 8:39 pm
Hi all,
so I've got my new printer, assembled, set up and calibrated it, opened a calibration box model in Contour - and voila, the printer doesn't start homing. Unplugged USB (COM6 port if it's important), turned off printer, then put it back - again nothing. Contour SW sees it on COM6, but no Homing. Any ideas why? other than bad karma..
Thank you!
so I've got my new printer, assembled, set up and calibrated it, opened a calibration box model in Contour - and voila, the printer doesn't start homing. Unplugged USB (COM6 port if it's important), turned off printer, then put it back - again nothing. Contour SW sees it on COM6, but no Homing. Any ideas why? other than bad karma..
Thank you!