Once in a while I get a completed print that is skewed to one side.
I often reprint in a new position or with more supports. And it may solve the problem.
The skew is usually in the side view on not in the through the finger hole view.
I just did one signet style were the top should be round and it is slight oval in the top down view.
I have been printing in 25xy 25z emerald resin. the prints in general have been amazing!
The bottle of resin is at the end And I am starting a new bottle soon.
I am looking for suggestions to solve the issue.
Thank you
slightly skewd prints
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: slightly skewd prints
Post a photo of the print and also of the scene.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: slightly skewd prints
Here are some images of some failed prints, In general do not save the scene on every print.
I will next time to see if it happens.
I usually print looking through the finger hole view, I do have this happen more in the other direction, not sure why that is.
thank you!
I will next time to see if it happens.
I usually print looking through the finger hole view, I do have this happen more in the other direction, not sure why that is.
thank you!
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: slightly skewd prints
I’ve only seen this being caused by overstretched film. The solution was to replace the film.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: slightly skewd prints
I will try that , thank you!
Who is online
Users browsing this forum: No registered users and 10 guests