Reify3D Forum

ive been getting a lot of failed prints
I have done everything I know to do
replaced the film.
recalibration of print head
clean and refocus all retina pathways
base exp is at 7s then at 1.5s I have tried down to 1.3s and up to 2.2s

it is printing the galery wires nad will fail the ring half way through the shank and for that matter anywere along the print.

the windows settings are all ok
please help

also im using .4 support tips and adding in a few .6tips at the bottom and half way up

this photo I had the base exp up to high

if I lay the ring on the side all prints well but just not when they are standing up
here are just a few photos

Which profile are you using? The default times for emerald, even at 25XY, are longer than what you've written.

How much resin is left in the bottle?

Mark, he is using a Vivitek 1186, Here in Australia we need to drop the exposure setting down really low with that projector, some customers are running between 1.2-1.9 sec for all.

I suggest setting back to default. You can do that with the reset button inside the resin profile window.

That looks like classic underexposure to me.

ive had the exp up to 2.5s and worked down and the base was at 15s

I think there has been several issues here

i am now running 8s for first layer then now 2s

i have also increced the base to 6mm with 1.5mm supports just to add extra stubility i have also gone from .3mm to .4mm with some manual supports at .6 at the bottom and halfway up and one .6 support at the top.

ive had my first two perfict prints i first thought it was a fluke like i had when i was at .3mm with 7s and 1.3s but i only had 1 good print in 10. now i have had 2 out of 2 joy lets make it 3 of 3

ill keep you posted