Hi, i have just started printing with Soluswax and all my prints come out with small holes and vertical lines.
I have never had this problem with other resins [B9 emerald green,Waxcast.]
I have calibrated platform,increased exposure time from 500 to 550 after a few failed prints, and checked lamp hours [598 h]
What else can i do?
Solus wax prints with small holes
Re: Solus wax prints with small holes
check FEP Film.
you print b9 put same position soluswax if have small hole I think FEP film issue
you print b9 put same position soluswax if have small hole I think FEP film issue
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Solus wax prints with small holes
Did you heat up the bottle and mix really good before printing? Are you using the latest profile for the soluswax?
As mentioned, might be time to replace film.
You could take some resin and fill in the holes and lines to save the print. Then UV it.
As mentioned, might be time to replace film.
You could take some resin and fill in the holes and lines to save the print. Then UV it.
Re: Solus wax prints with small holes
I have replaced the film and the print was ok thanks.
Who is online
Users browsing this forum: No registered users and 9 guests