Reify3D Forum

Hi, i have just started printing with Soluswax and all my prints come out with small holes and vertical lines.
I have never had this problem with other resins [B9 emerald green,Waxcast.]
I have calibrated platform,increased exposure time from 500 to 550 after a few failed prints, and checked lamp hours [598 h]
What else can i do?

check FEP Film.
you print b9 put same position soluswax if have small hole I think FEP film issue

Did you heat up the bottle and mix really good before printing? Are you using the latest profile for the soluswax?

As mentioned, might be time to replace film.

You could take some resin and fill in the holes and lines to save the print. Then UV it.

I have replaced the film and the print was ok thanks.