Solus wax prints with small holes

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
ALEXSAR13
Novice
Posts:13
Joined:Thu Jul 28, 2016 5:08 am
Location:Greece
Solus wax prints with small holes

Postby ALEXSAR13 » Sat Sep 29, 2018 8:27 am

Hi, i have just started printing with Soluswax and all my prints come out with small holes and vertical lines.
I have never had this problem with other resins [B9 emerald green,Waxcast.]
I have calibrated platform,increased exposure time from 500 to 550 after a few failed prints, and checked lamp hours [598 h]
What else can i do?
Attachments
P9292562.JPG
P9292561.JPG
User avatar
exedebee
Solus Expert
Posts:128
Joined:Fri Feb 12, 2016 3:39 am

Re: Solus wax prints with small holes

Postby exedebee » Sat Sep 29, 2018 11:09 am

check FEP Film.
you print b9 put same position soluswax if have small hole I think FEP film issue
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:

Re: Solus wax prints with small holes

Postby Jewelermdt » Mon Oct 01, 2018 3:22 am

Did you heat up the bottle and mix really good before printing? Are you using the latest profile for the soluswax?

As mentioned, might be time to replace film.

You could take some resin and fill in the holes and lines to save the print. Then UV it.
ALEXSAR13
Novice
Posts:13
Joined:Thu Jul 28, 2016 5:08 am
Location:Greece

Re: Solus wax prints with small holes

Postby ALEXSAR13 » Mon Oct 01, 2018 1:09 pm

I have replaced the film and the print was ok thanks.

Who is online

Users browsing this forum: No registered users and 6 guests