Recently I have had failed prints.
I have calibrated print plate several times (used 0,06mm, 0,10mm, 0,11, 0,13 paper and old film) and replaced film.
Computer settings are ok (RGB etc.). No automatic updates.
I have tried different thumbscrew "settings", even fully loosen (so no tigntening at all and vat is "floting").
Quartz, teflon, lenses and mirrors are clean. Resin is well shaked with heat and nuts and bolts.
Printer and projector are about 2months old, so it shouldnt be lamp.
What should I try next?
Failed prints
Last edited by Mikkopee on Wed Oct 17, 2018 4:56 am, edited 1 time in total.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Failed prints
Who did you get the printer from? I suggest contacting them, so they can help you do some diagnostics and check everything with your setup.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Failed prints
mongerdesigns wrote:Who did you get the printer from? I suggest contacting them, so they can help you do some diagnostics and check everything with your setup.
Its from Jordi and he is helping me with this. Just wanted to make thread coz this might help somebody else with similar problems.
Jordi´s support has been great!
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Failed prints
Ok. I'm sure Jordi is on it, and will help you figure it out.
If I had to give advice, I would say increase the exposure time by about 0.5s.
If I had to give advice, I would say increase the exposure time by about 0.5s.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 6 guests