Print failure x 100

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
cruew
Posts:8
Joined:Wed Dec 14, 2016 2:08 am
Print failure x 100

Postby cruew » Wed Oct 17, 2018 4:07 am

Hi guys,

I hope you're doing well !!

I spent most of today trying to solve my issue, but I haven't had any luck

The problem is when I print, the base itself is able to print onto the build platform, but the remainder of the prints are stuck and printed on the vat

Like this:

https://imgur.com/a/dZI40Hv

So far I have done the following:
- plate calibration
- used 80 grit sandpaper on the build plate
- fresh resin
- tried 2 different vats
- print @ 25 microns + 41.7 microns
- configure the graphic settings

Does anyone have any suggestions on how to fix this issue?

Thank you in advance!
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Print failure x 100

Postby mongerdesigns » Wed Oct 17, 2018 5:11 pm

I see the film is getting stuck to the glass. That usually can happen if there is residue on the glass or the bottom of the film.

Clean really well using microfiber cloth and alcohol, or zeiss lens wipes.

Also, post a few screenshots of the scene, so we can see what you're trying to print.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/

Who is online

Users browsing this forum: No registered users and 9 guests