Hi guys,
I hope you're doing well !!
I spent most of today trying to solve my issue, but I haven't had any luck
The problem is when I print, the base itself is able to print onto the build platform, but the remainder of the prints are stuck and printed on the vat
Like this:
https://imgur.com/a/dZI40Hv
So far I have done the following:
- plate calibration
- used 80 grit sandpaper on the build plate
- fresh resin
- tried 2 different vats
- print @ 25 microns + 41.7 microns
- configure the graphic settings
Does anyone have any suggestions on how to fix this issue?
Thank you in advance!
Print failure x 100
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print failure x 100
I see the film is getting stuck to the glass. That usually can happen if there is residue on the glass or the bottom of the film.
Clean really well using microfiber cloth and alcohol, or zeiss lens wipes.
Also, post a few screenshots of the scene, so we can see what you're trying to print.
Clean really well using microfiber cloth and alcohol, or zeiss lens wipes.
Also, post a few screenshots of the scene, so we can see what you're trying to print.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 12 guests