Print failure x 100
Posted: Wed Oct 17, 2018 4:07 am
Hi guys,
I hope you're doing well !!
I spent most of today trying to solve my issue, but I haven't had any luck
The problem is when I print, the base itself is able to print onto the build platform, but the remainder of the prints are stuck and printed on the vat
Like this:
https://imgur.com/a/dZI40Hv
So far I have done the following:
- plate calibration
- used 80 grit sandpaper on the build plate
- fresh resin
- tried 2 different vats
- print @ 25 microns + 41.7 microns
- configure the graphic settings
Does anyone have any suggestions on how to fix this issue?
Thank you in advance!
I hope you're doing well !!
I spent most of today trying to solve my issue, but I haven't had any luck
The problem is when I print, the base itself is able to print onto the build platform, but the remainder of the prints are stuck and printed on the vat
Like this:
https://imgur.com/a/dZI40Hv
So far I have done the following:
- plate calibration
- used 80 grit sandpaper on the build plate
- fresh resin
- tried 2 different vats
- print @ 25 microns + 41.7 microns
- configure the graphic settings
Does anyone have any suggestions on how to fix this issue?
Thank you in advance!