Drop in intensity on infocus projector

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:
Re: Drop in intensity on infocus projector

Postby Jewelermdt » Sun Dec 09, 2018 3:37 am

A lot depends on bulb age- hours of use. I had just put in a new bulb. My setting in the projector menu I believe is at 50 or 55%. If you have a lot of hours on the bulb, you might need 60% to 65%. It's a trial and error thing.

Course other things could be culprit , like film tension, dents in it, resin on lens or front glass of printer.
podivo
Novice
Posts:15
Joined:Fri Jul 10, 2015 12:00 pm

Re: Drop in intensity on infocus projector

Postby podivo » Tue Dec 11, 2018 11:08 am

Thank you,
I will try to play with setting.
Pavol
robin
Solus Expert
Posts:144
Joined:Wed Sep 23, 2015 3:03 pm

Re: Drop in intensity on infocus projector

Postby robin » Wed Mar 06, 2019 1:23 pm

If you hear too much noises while printing, try lowering the z-lift speed when printing large pieces like that. b9 resins (especially yellow and emerald) are really sticky.

Who is online

Users browsing this forum: No registered users and 9 guests