Can not do homing after changing film

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
petertruong07
Posts:8
Joined:Fri Oct 20, 2017 2:40 am
Can not do homing after changing film

Postby petertruong07 » Tue Nov 06, 2018 5:59 pm

Hi,
My printer doesn’t do homing after I changed the film. Any help is appreciated
Peter
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Can not do homing after changing film

Postby mongerdesigns » Tue Nov 06, 2018 7:41 pm

Peter, just replied to your email.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
petertruong07
Posts:8
Joined:Fri Oct 20, 2017 2:40 am

Re: Can not do homing after changing film

Postby petertruong07 » Tue Nov 06, 2018 8:42 pm

Emil
Thank you
I think the cable is loose
OpedHead
Novice
Posts:41
Joined:Wed Sep 14, 2016 2:27 am
Location:Melbourne, Australia

Re: Can not do homing after changing film

Postby OpedHead » Fri Nov 30, 2018 10:34 am

Reset button on the back!
I was in the same sitch once and tried resetting the computer, turning the printer and projector off and on with no result, reset button on the back of the printer was the savior. Also the printer power cable can get loose, not sure what your US plugs are like but we bend our wall plug pins toward each other to make them stay in better sometimes ;)

Who is online

Users browsing this forum: No registered users and 9 guests