Layering in print
Posted: Thu Dec 20, 2018 1:41 pm
Hey guys,
I'm printing with Proto at 25xy and 10z. I'm building straight onto the build plate.
I've noticed some very heavy layering lines in the model. They're occurring at the thickest section of the model (the mane) but are disappearing at the smaller cross-section (face).
This would indicate to me that the resin isn't separating from the film cleanly. I'm using new film, so would this be a tension problem? Do I have the film too tight or too lose? Are there any other factors I should consider?
Thanks for the help,
Aaron
I'm printing with Proto at 25xy and 10z. I'm building straight onto the build plate.
I've noticed some very heavy layering lines in the model. They're occurring at the thickest section of the model (the mane) but are disappearing at the smaller cross-section (face).
This would indicate to me that the resin isn't separating from the film cleanly. I'm using new film, so would this be a tension problem? Do I have the film too tight or too lose? Are there any other factors I should consider?
Thanks for the help,
Aaron