Problem printing

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
yiftachd
Posts:4
Joined:Sat Jan 26, 2019 8:42 pm
Problem printing

Postby yiftachd » Sat Jan 26, 2019 9:09 pm

Hi,

We have a solus 3d printer in our lab which was installed and used successfully last year. I recently tried to print a rectangular object with holes that go through it:
Capture.PNG

, just as a test because the printer wan't used for a while.

I didn't get well defined vertices and I didn't get holes (On one face I could see circles, though). The side faces look more like different sheets attached together rather than as continuous faces. Here are pictures of the different faces:

20190126_223641.jpg

20190126_223618.jpg

20190126_223603.jpg

20190126_223542.jpg


I checked the configurations according to the manual and they seem to be ok. What could be the problem?

Thanks in advance,
Yiftach
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Problem printing

Postby mongerdesigns » Sat Jan 26, 2019 10:51 pm

Check your RGB settings (in the manual). If the graphics driver is not in FULL RGB mode, the background will not be dark enough and will slightly cure the resin every layer.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
yiftachd
Posts:4
Joined:Sat Jan 26, 2019 8:42 pm

Re: Problem printing

Postby yiftachd » Sun Jan 27, 2019 6:59 am

I checked the settings, and it's on full RGB mode.

Who is online

Users browsing this forum: No registered users and 2 guests