base
My base are not .5mm they are .29 .25 on a yellow and cherry. What do I need to change fix. Also does temperature affect the prints.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: base
Do you mean you made them .5mm and they come out .3? If so they that's normal. It's from the compression of the initial layers. Your build table is probably calibrated to tight down, which is fine.
Extreme temps can affect prints. I keep the office at about 73F and it works out fine. Too cold might cause issues.
Extreme temps can affect prints. I keep the office at about 73F and it works out fine. Too cold might cause issues.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 5 guests