Page 2 of 2

Re: Warped Prints

Posted: Sat Nov 23, 2019 10:36 pm
by emild
hasd81 wrote:I’m getting the same thing with my prints, same height every time.


Anyone solved this ????

Re: Warped Prints

Posted: Mon Nov 25, 2019 6:02 pm
by Kokos
If it is not your support or your film not being flat. You can also try and mount the Z-axis screw upside down. Then if it would have a bad spot it would be in a different location. Unless it is exactly in the middle.

Re: Warped Prints

Posted: Fri Oct 02, 2020 5:41 pm
by icibis
Did you ever figure out a fix for this? I have the same issue, but only with castable resins (emerald and soluscast). Art grey and solusproto work fine.