Circle pendant coming out egg shaped
So I am trying to print a large scarf pin that is to be a 54mm domed circle and it is coming out wonky. The Y dimension is right but the X dimension seems to be squeezed in. I Calibrated the printer with a 10x10x10mm test print before this one as well. Has anyone calibrated the printer with a larger test cube? Say 30x30x30mm so that if the caliper measurements are off a little it might not make a difference when printing larger items?
Re: Circle pendant coming out egg shaped
Is the back of the scarf pin hollowed out? Maybe it is shrinkage of the resin due to the geometry?
I wonder if you print it on its back with elevated supports versus at an angle, would it do the same thing?
I wonder if you print it on its back with elevated supports versus at an angle, would it do the same thing?
Re: Circle pendant coming out egg shaped
rkundla wrote:Is the back of the scarf pin hollowed out? Maybe it is shrinkage of the resin due to the geometry?
I wonder if you print it on its back with elevated supports versus at an angle, would it do the same thing?
It's too large to print on its back, but yes it is hollow in the back
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Circle pendant coming out egg shaped
Try using bigger touch points. They look small. Also put some inside the holes to support the top side. Maybe rotate it 90 degrees and see it that helps.
Who is online
Users browsing this forum: No registered users and 42 guests