grid squished
I recently did an update and afterwards was getting consistently bad prints. I checked to make sure everything was correct, updated contour, checked the projector settings, and double checked the graphics settings. I went through the entire setup over again and now I'm getting a squished grid projection. The dial is all the way over to the side so I can't enlarge it any bigger. Any ideas?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: grid squished
Seems like the wrong aspect ratio is selected. Either in the projector menu or graphics card menu.
Check the resolution of the projector too to make sure it's on 1920x1080 pixels.
Check the resolution of the projector too to make sure it's on 1920x1080 pixels.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 9 guests