Page 1 of 1

Solus Art Grey Resin trouble

Posted: Wed May 13, 2020 9:04 am
by Robert
Hi folks,

Has anyone had all manner of trouble with this Art grey resin? I have tried 5 prints, a lot of different settings and all I can muster is some grey resin discs stuck to the plate, with no supports building.

Are there any settings people suggest?

Should I be using thicker supports?

Cheers
Rob

Re: Solus Art Grey Resin trouble

Posted: Wed May 13, 2020 12:26 pm
by Mikkopee
Robert wrote:Hi folks,

Has anyone had all manner of trouble with this Art grey resin? I have tried 5 prints, a lot of different settings and all I can muster is some grey resin discs stuck to the plate, with no supports building.

Are there any settings people suggest?

Should I be using thicker supports?

Cheers
Rob

Have you tried other resins? Lamp hours?

Re: Solus Art Grey Resin trouble

Posted: Thu May 14, 2020 12:41 am
by Jewelermdt
Make sure you're using the correct resin profile for printing it? Ghost run around in my computer, especially after an windows update.
I think I have seen where you might need to use bigger support tips and tubes. A lot depends on what your printing. Large items need bigger supports. I have to increase my sizes using Solus Wax Pro for things like bracelets.