get the build plate out of the vat.

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
SidStevens
Posts:2
Joined:Tue Oct 31, 2017 3:24 pm
get the build plate out of the vat.

Postby SidStevens » Wed Sep 15, 2021 12:31 am

Had a power outage while printing.
The plate is stopped down in the vat.
How do I get the plate back up out of the vat?
I am afraid if I hit home it will impact the vat and damage the printer.
I now have a battery backup so this won't happen again.
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: get the build plate out of the vat.

Postby mongerdesigns » Wed Sep 15, 2021 4:23 am

Turn the power off from the back, then open the lid and turn the lead screw by hand until the arm moves up about half way up. Then remove the build plate and resin tank.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
SidStevens
Posts:2
Joined:Tue Oct 31, 2017 3:24 pm

Re: get the build plate out of the vat.

Postby SidStevens » Wed Sep 15, 2021 4:22 pm

That was easy!!!
Thanks so much!

Who is online

Users browsing this forum: No registered users and 5 guests