Page 1 of 1

Print not touching to platform.

Posted: Sat Jun 01, 2024 10:19 am
by simong
Dear friends,
I used to use solus printer long back. after a year I am trying to print some jobs.
But model not sticking on platform and giving me this kind of model,
(Picture is attached, I print total 6 different models, and all had same issues)
Can you help me, what can cause this issue on the print?

Re: Print not touching to platform.

Posted: Thu Jul 04, 2024 9:25 am
by sochin
I think this forum is pretty much abandoned @simong.. Can you post a screenshot of the build in contour? Even if I can't help at least others (if any visit here) will be able to see what you are trying to build and might help to figure out what is happening. Might be the setup of the build re supports and angles, the resin, settings or tray film.

cheers,
Sochin

Re: Print not touching to platform.

Posted: Thu Jul 04, 2024 9:27 am
by sochin
BTW simong, what is the resin, how old is it and has it been sitting in the tray or in the bottle?

cheers,
Sochin