Supports question

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Post Reply
User avatar
Archerm
Solus Master
Posts:599
Joined:Mon Oct 26, 2015 1:57 pm
Location:North Carolina
Supports question

Postby Archerm » Mon Jan 25, 2016 8:03 pm

Hey everyone!! Just sold this piece today!! I am happy about that! Any suggestions on how to start supporting this? I was thinking about a 25* tilt . It has lots of little over hangs so I think I will add some bridges to the model first. Then supports underneath. I have found that Tilt gives such a better finish. Thanks Mark

Image
Top
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:
Contact mongerdesigns

Re: Supports question

Postby mongerdesigns » Mon Jan 25, 2016 8:42 pm

Hi Mark,

Would have to look at the STL but seems simple enough. I don't think titling the model will add anything unless you have large horizontal areas to support.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
Top
Post Reply

Return to “Help and Troubleshooting”

Who is online

Users browsing this forum: No registered users and 57 guests