Hi
Since today, I'm having some problem with the z motor. The homing works fine and when I want to do a new printing (after a first printing) the z motor stop at something like 2-3cm from the printing position. In general, restarting the system works and allow to do a new printing, but again when I want to do a new printing the motor stop after several centimeters of displacement.
When the motor stop moving it is making a small buzz noise.
Thanks
Sebastien
Z motor not moving properly
-
- Novice
- Posts:50
- Joined:Mon Jan 25, 2016 8:01 am
Re: Z motor not moving properly
Hi,
This sounds like a firmware or Gcode issue. I'll email you now.
This sounds like a firmware or Gcode issue. I'll email you now.
Who is online
Users browsing this forum: No registered users and 39 guests