Resin calibration tool within CW

[hx19035]

Has anyone tried to use this function? I put the appropriate amount of PIC100 resin in the vat and tried it out. It printed a cool looking baffle but I'm not sure what I'm supposed to measure. Is there a write-up on how to take advantage of this little tool?

I'd really like to tweak the settings for PIC100 as it seems to cast so well.

Thanks!!

[Argyle]

I'm not 100% sure how to use it but I know each box should have a thin cured layer spanning the top. I think the idea is to pick the first box that prints correctly and set it as your exposure time.