Good Morning All;
I am having trouble printing this bangle bracelet and am looking for any suggestions for a successful print?
I have spruced this up 3 different ways and still no success for the bottom half. And even with the bottom now printing the top comes out with a fixable crack.
It is a 5 hour 45 minute print that runs close to 6 hours 25 minutes. Was going to try and load the build file, but the forum will not accept the stl file.
Any suggestions would be appriciated?
Toddmichael
Help Printing Bangle
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
Re: Help Printing Bangle
Hi Todd,
Did you get it to print? If not, please send the stl to reify3d@gmail.com and I'll take a look.
Did you get it to print? If not, please send the stl to reify3d@gmail.com and I'll take a look.
- toddmichael
- Novice
- Posts:77
- Joined:Sun Jul 05, 2015 4:33 am
- Location:Motor City, Mi
Re: Help Printing Bangle
Mark;
I broke it into 2 sections and printed it last night, worked ok. I am doing another bangle now and if I run into it again, will definitely email.
I am thinking as the print time is longer over a normal 2 to 3 hour print the resin might start to break down as we see it does sitting around.
I print a bangle a week or more, and really need to get these down to a science. Rings and pendants are doing a lot better.
Toddmichael
I broke it into 2 sections and printed it last night, worked ok. I am doing another bangle now and if I run into it again, will definitely email.
I am thinking as the print time is longer over a normal 2 to 3 hour print the resin might start to break down as we see it does sitting around.
I print a bangle a week or more, and really need to get these down to a science. Rings and pendants are doing a lot better.
Toddmichael
Toddmichael
Firestorm Cad / Jeweler / Designer
Firestorm Cad / Jeweler / Designer
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Help Printing Bangle
Will they fit laying flat? Be a lot quicker.
Who is online
Users browsing this forum: No registered users and 94 guests