Monger Designs a.k.a. Monger
Solus R&D, Resin R&D, Support, CAD and 3d printing expert
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Top
Previous PMNext PMMove to folder: Inbox
Expand viewMessage history:
Re: hardware problems
Sent: Mon Sep 21, 2015 1:15 am
by podivo
mongerdesigns wrote:Hi Pavol,
You can recalibrate the build plate. Loosen the 4 hex screws. Put a piece of paper on the top glass. Home with the build plate on. Push down on the build plate and make sure all the corners are touching. Then slowly tighten the screws. That's it.
Hi,
It is two weeks what I am testing printer.
I have everything setting under manual ,but every print goes to failure.
I do not know why happen things like this:
for example: When I push slick button projector start to project pictures.
sometimes slice is stick only on film ,but not on built plate.
Often happens that print is doing well ,but projector will stop project with some reason....after few minutes.
Pavol
problems with setting
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: problems with setting
Pavol,
It seems to me like a computer issue. Mark tried to contact you to help you figure it out. Did you get his email?
It seems to me like a computer issue. Mark tried to contact you to help you figure it out. Did you get his email?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 29 guests