print fail, seem projector lamp too old

[haipham]

I cant not print someday ago. Projector light is flicker, flash when eco mode, normal mode no flicker but i cant print successfull. Fail at end of support, have some strange surface solid at model. Pls help me. My project hourse is 3500h eco and 150 normal

[mongerdesigns]

3500 hours is way past due for a replacement. We recommend replacing the bulb at 2000 hours.

[haipham]

how can i replacement for vivitek 1186
Any suggest for lamp bulb buying
Thanks for help, i cant do anything in 2 months, dont know what problem but print cannot successful because model seems blur on project

[reify]

Hi,

I am waiting for pricing of replacement bulbs from Vivitek. I'll email you when I know.

[haipham]

Hi,

I am waiting for pricing of replacement bulbs from Vivitek. I'll email you when I know.

Now i cant $h, motor not stop when go home, and can go up in solus

[Jewelermdt]

Turn off power to printer. Turn Z screw by hand to raise up. Power on, restart CW.. You should get the Contour software. It's much easier to use.

[haipham]

i run home cycle in solus but when z go to home position, motor still run, after a few second motor stop but software still load, dont recognise that home, dont go up

[barth]

Sometime I have the same problem, for me the problem was a too tight VAT the quartz can't till properly.

[rkundla]

Thanks for help, i cant do anything in 2 months, dont know what problem but print cannot successful because model seems blur on project

If you got a blurry projection and it doesn't appear to be focus-related, then you have some other issue, like dirty filter glass or internal optics inside the projector itself that needs to be dealt with first.

[haipham]

3500 hours is way past due for a replacement. We recommend replacing the bulb at 2000 hours.

When in eco mode, picture project on wall are flicker, normal mode resolve it but cant still print