+10 go to +50
And seem machine remember last position like home position
Pls help me troubleshoot
before have stuck in motor title because resin and i had replate with old
Thanks Mark help
[solve] Seem z axis error
I run home but z axis dont move, stuck and have noise, when i push home sensor, it stop motor but seem z axis not move. After run home, i still up down + 1 +10 but +1 go +10
+10 go to +50
And seem machine remember last position like home position
Pls help me troubleshoot
before have stuck in motor title because resin and i had replate with old
Thanks Mark help
+10 go to +50
And seem machine remember last position like home position
Pls help me troubleshoot
before have stuck in motor title because resin and i had replate with old
Thanks Mark help
Last edited by haipham on Mon Apr 17, 2017 6:29 am, edited 1 time in total.
-
Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: [urgent] Seem z axis error :(
unplug the power. Turn the screw by hand to raise it up. Plug back in. Restart everything. Then try home. Be sure your vat is not to tight. Just barely tighten screws.
Re: [urgent] Seem z axis error :(
Jewelermdt wrote:unplug the power. Turn the screw by hand to raise it up. Plug back in. Restart everything. Then try home. Be sure your vat is not to tight. Just barely tighten screws.
try all there but cant solve
Who is online
Users browsing this forum: No registered users and 5 guests