Z lift speed

[mongerdesigns]

Check your full RGB settings, per the instructions.

[Waever]

Where and how do I find the profile folder?

Would like to slow mine down a little (tilt speed) . I ve been using solus proto and have reduced exposures right right down from the default setting and only now is it starting to work.

At the default settings the result were as attached in the picture! my tea cup says it all on about that one!

Now when I reduced exposures to 0.75 sec the flappy bits have all but nearly vanished on subsequent tests..... nearly there now I hope!

Scale is great, the z height is totally bang on as is the Y.......... X is I think less than 0.07mm out.

I am looking to make a slightly more gentle peel action...........to alter the speed of tilt as there are a kinda faint drag lines in some areas on sides.

Do you open a folder rather than launching contour application to find the tilt speed?

Thanks.

that flappy thing on your print, looks like the RGB not full my friend.