Page 1 of 1

Ring print bigger size

Posted: Thu Dec 27, 2018 10:13 am
by dcpattni
Hello Everyone,

I had problem with printing 2 ring long time when i managed @30z ring size is bigger.....cad guy also recheck all fine.....printed 4 times same ring... I and cad guy have not add sinkage....i can share same ring SC file....anyone have idea why?

below i have attached screenshot for calibration sample full platform but i have noticed preview and grid on screen match..printer grid and printer paper grid matches....is it correct?..many times if i print full platform its different sizes center,conner etc.


regards,
DIpen

Re: Ring print bigger size

Posted: Thu Dec 27, 2018 6:22 pm
by mongerdesigns
You're doing it wrong. Reset your grid. Don't adjust the size of the grid through software. That module is only for adjusting the spherical distortion. You need to adjust the size of the grid using the physical zoom dial on the projector.

Re: Ring print bigger size

Posted: Fri Jan 04, 2019 7:36 pm
by dcpattni
Anyone got such problem before.
I have elephant pose in right view i did mirror in 3D builder to left view then both file open in SC....after i save SC file and reopen SC file dimension change it self....below screenshot.....first time i did print like this i didn't no..after cleaning and casting found why 0.4-0.6mm difference.

but if i don't save file n put support then print it looks ok on SC dimension but after cutting the supports i see its little bit change dimension both don't match same size.

also noticed after i scaling to 150% open STL file it will automatically do scaling which ever last was checked it will go on that scaling.

hope you understand what i'm trying to say.

regards,
dipen