Hey Guys
I just received the Solus printer, but have been unable to get it to print properly.
I am trying to print the Solus sample ring, but only part of the sprue prints and a base covering the entire build area forms on the film of the vat. I've tried using both Creation Workshop and the new Solus software, but the same thing happens. I've also recalibrated the build platform. Below are images of what is happening.
Print Not Working
-
- Novice
- Posts:11
- Joined:Wed Jul 06, 2016 3:39 am
Re: Print Not Working
Hi,
Your projector is printing the full build area. Please enable full RGB as explained in the manual.
Your projector is printing the full build area. Please enable full RGB as explained in the manual.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Print Not Working
Ya. I think following the setup instructions carefully will help.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- CADjewelrySchool
- Novice
- Posts:71
- Joined:Wed Sep 16, 2015 10:28 am
Re: Print Not Working
Hi Nikhil.
Your projector was setup and we did 2-3 test prints before shipping.
The over curing is 100% to do with setting on your video card.
Give me a call/email and I can go through it with you.
Rik
Your projector was setup and we did 2-3 test prints before shipping.
The over curing is 100% to do with setting on your video card.
Give me a call/email and I can go through it with you.
Rik
-
- Novice
- Posts:11
- Joined:Wed Jul 06, 2016 3:39 am
Re: Print Not Working
Hi Rik
I've just sent you an email - the dynamic range is set to full and this the result.
I've just sent you an email - the dynamic range is set to full and this the result.
Re: Print Not Working
This is for sure the RGB problem. Are you using Intel or Nvidia graphics? HDMI or VGA?
-
- Novice
- Posts:11
- Joined:Wed Jul 06, 2016 3:39 am
Re: Print Not Working
Nvidia with HDMI.
Re: Print Not Working
Please email me at reify3d@gmail.com and I can hook up to your computer to take a look.
- CADjewelrySchool
- Novice
- Posts:71
- Joined:Wed Sep 16, 2015 10:28 am
Re: Print Not Working
Did you change to FULL RGB in the section in the nVidia driver settings called "Display" I think on your driver they should be in the link called "Change resolution" or "Adjust desktop color settings".
-
- Novice
- Posts:11
- Joined:Wed Jul 06, 2016 3:39 am
Re: Print Not Working
OK, so I changed to a VGA cable and it now works - see attached image (not the best quality image).
I've checked the Solus sample ring STL file and the detail is all there and the measurements are correct.
I've checked the Solus sample ring STL file and the detail is all there and the measurements are correct.
Who is online
Users browsing this forum: No registered users and 90 guests